Gravure engraver If you want to ensure long-term normal use, then you need to pay attention to the maintenance of the machine. The running time of the engraving machine is preferably controlled to be less than 10 hours per day. When cleaning, ensure the cleaning of the cooling water and the normal operation of the pump. The water motor of the water spindle must not be dehydrated. The cooling water of the engraving machine is to prevent the water from being too high and cause damage to the machine. If it is winter, if the working environment temperature is too low, then the water in the water tank can be replaced with antifreeze.
Note that the engraving machine should pay attention to cleaning every time it is used. When cleaning, it is necessary to clean the dust on the platform and the transmission system. Regularly (weekly) lubricate the transmission system (ie X, Y, Z three axes). The three-axis polished rod is to be maintained with oil, while the screw portion requires high-speed butter. If the ambient temperature is too low in winter, the PRTT ball screw and polished rod, that is, the square guide rail and the circular guide rail part, need to be flushed and cleaned with gasoline first, and finally the oil is added, otherwise the resistance of the transmission part of the machine will be too large, resulting in excessive resistance. The machine is misplaced.
Of course, the most important point is that when the appliance is inspected for maintenance, it is necessary to cut off the power of the machine, and wait until the monitor has no display and the power indicator of the main circuit is extinguished before cleaning and maintenance work can be performed.
Language
Spanish
